- 您现在的位置：买卖IC网 > Sheet目录868 > LTM4603IV#PBF (Linear Technology)IC DC/DC UMODULE 6A 118-LGA
LTM4603/LTM4603-1
OPERATION
Power Module Description
The LTM4603 is a standalone nonisolated switching mode
DC/DC power supply. It can deliver up to 6A of DC output
current with few external input and output capacitors.
This module provides precisely regulated output voltage
programmable via one external resistor from 0.6V DC to
5.0V DC over a 4.5V to 20V wide input voltage. The typical
application schematic is shown in Figure 18.
The LTM4603 has an integrated constant on-time current
mode regulator, ultralow R DS(ON) FETs with fast switching
speed and integrated Schottky diodes. The typical switching
frequency is 1MHz at full load. With current mode control
and internal feedback loop compensation, the LTM4603
module has sufficient stability margins and good transient
performance under a wide range of operating conditions
and with a wide range of output capacitors, even all ceramic
output capacitors.
Current mode control provides cycle-by-cycle fast current
limit. Besides, foldback current limiting is provided in an
overcurrent condition while V FB drops. Internal overvolt-
age and undervoltage comparators pull the open-drain
PGOOD output low if the output feedback voltage exits a
±10% window around the regulation point. Furthermore,
in an overvoltage condition, internal top FET Q1 is turned
10
off and bottom FET Q2 is turned on and held on until the
overvoltage condition clears.
Pulling the RUN pin below 1V forces the controller into its
shutdown state, turning off both Q1 and Q2. At low load
current, the module works in continuous current mode by
default to achieve minimum output ripple voltage.
When DRV CC pin is connected to INTV CC an integrated
5V linear regulator powers the internal gate drivers. If a
5V external bias supply is applied on the DRV CC pin, then
an efficiency improvement will occur due to the reduced
power loss in the internal linear regulator. This is especially
true at the high end of the input voltage range.
The LTM4603 has a very accurate differential remote
sense amplifier with very low offset. This provides for
very accurate output voltage measurement at the load.
The MPGM pin, MARG0 pin and MARG1 pin are used to
support voltage margining, where the percentage of margin
is programmed by the MPGM pin, and the MARG0 and
MARG1 select margining.
The PLLIN pin provides frequency synchronization of the
device to an external clock. The TRACK/SS pin is used
for power supply tracking and soft-start programming.
4603fb
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
LTM4604AIV#PBF
IC UMODULE DC/DC LV 4A 66-LGA
LTM4604IV#PBF
IC DC/DC UMODULE 4A 66-LGA
LTM4605EV#PBF
IC DC/DC UMODULE 5A 141-LGA
LTM4606MPV#PBF
IC DC/DC UMODULE 6A 133-LGA
LTM4607IV#PBF
IC BUCK/BOOST SYNC ADJ 5A 141LGA
LTM4608AEV#PBF
IC BUCK SYNC ADJ 8A 68LGA
LTM4608IV#PBF
IC DC/DC UMODULE 8A 68-LGA
LTM4609IV#PBF
IC BUCK/BOOST SYNC ADJ 4A 141LGA
相关代理商/技术参数
LTM4603IV#PBF
制造商:Linear Technology 功能描述:DC/DC uModule IC
LTM4603IV-1#PBF
功能描述:IC DC/DC UMODULE 6A 118-LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:100V 电压 - 输入（最大）:200V Voltage - Output 1:7.5V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:100W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-SlimMod 尺寸/尺寸:4.60" L x 1.80" W x 0.52" H（116.8mm x 45.7mm x 13.2mm） 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源（瓦特）- 最大:*
LTM4603IV-1-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:6A DC/DC μModule with PLL, Output Tracking and Margining
LTM4603IV-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:6A DC/DC μModule with PLL, Output Tracking and Margining
LTM4603V
制造商:LINER 制造商全称:Linear Technology 功能描述:6A DC/DC μModule with PLL, Output Tracking and Margining
LTM4603V-1
制造商:LINER 制造商全称:Linear Technology 功能描述:6A DC/DC μModule with PLL, Output Tracking and Margining
LTM4604
制造商:LINER 制造商全称:Linear Technology 功能描述:Low Voltage, 4A DC/DC μModuleTM with Tracking
LTM4604A
制造商:LINER 制造商全称:Linear Technology 功能描述:Low Voltage, 4A DC/DC μModule with Tracking